Loading ...
Loading ...
Loading ...
TRIMMERHEADLINEINSTALLATION
SMALLBUMPFEEDHEAD(,,080"Line)
1Reviewfigure28fornamesofpartsreferredtointhese
instructions,
8,Continuewindingcord in direction indicated as
shown, leave about 6 inches free length (15-20 cm)
to pull wire through holes in body. Snap the lines
through top notches in reel (Fig, 26 and Fig.,27)°
2 Lockshaft by inserting allen keyinto hole incollar and turn
until it engages groove inside,When shaftcan no longer
rotate, loosen head byturning it asshown (Fig,24).
3,Loosen bump feed button and remove byturning CCW
(Fig_25),
Wrap Bottom CCW
Fig 2.7
9, Feed the free ends of _____Q_J Body
lines through holes in _1 I I It! Spr_ng
body while inserting _-CT-[-_
reel back into body
Hold reel in place
against spring pres * Reel
sure (Fig_28).
Fig .25
4. Pull reel out of trimmer body, take care to not lose
the spring behind it.,
5_Un-wind and remove the remnants of the line left on
the reeloNote how the ends of the line are hooked in
place and the direction it is wound°
& If using new line from a bulk spool, cut 2pieces of
line 7..5ft (2°28 m) long. Insert each line into one of
the holes on each retention hook opposite of the
direction of the rotation about1!2 inch deep.
7_
Wrap line 180° and wind extra line in the opposite
direction of rotation of the head as shown (Fig.,26),
Retentfon
Hook
._..--.._ Bump Feed
Button
4-- Nut
Fig,2B
t0. While holding reel into body, screw bump feed but -
ton and nut onto threads by turning CW(Fig, 29).
Ftg.29
11..insert allen key into hole tighten by turning body as
shown (Fig, 30)..
Fig, 26
Fig,30
NOTE: Always use original equipment manufacturer replacement line, Lines other than those
specified may make the engine overheat or fail.
LEHR I ALL RIGHT RESERVED 2008-2009
Loading ...
Loading ...
Loading ...