Loading ...
Loading ...
Loading ...
TRIMMER HEAD LINE iNSTALLATION
LARGEBUMP FEEDHEAD (,095" Line)
1.Lock shaft by inserting allen key into groove_ Loosen
by turning head asshown for straight shaft,,if your
model is acurved shaft, loosen by turning opposite
the direction shown in (Fig. 3t),.
2, Depress tab and twist trimmer head body CWto
disassemble (Fig, 32)_
Rg31
. Tab
Top vie___
"_ "Trimmer Head Body
Fig32
3. Ifusing new line from a bulk spool, cut 2pieces of
line 7.,5'(2.28 m) long. Insert each line into one of the
holes on each retention hook opposite of the direc -
tion of the rotation about 1/2 in (12-7 ram) deep
4oWrap line !80 °and wind extra line in the opposite
direction of rotation of the head (Fig_33)°
Retention
Hook
6oSnapthe freelength of linesinto top grooves in reeland pull
through holeson trimmer head body (Fig°34and Fig.35),
Trimmer Head
Body
_-----Sp ting
I
,_-.---- Bump Feed
Bullon
Trimmer Head Body
Fig35 Bottom
7 Close assembly in sequence as shown in (Fig° 35)°
8, Reassemble by lining up the 4 tabs on trimmer head
body and bottom,, Turn CCWuntil "click" (Fig. 36).
Tab *dick"
Fig 36
9.,Insert allen key into hole, tighten head by turning
asshown for curved shaft and opposite for straight
shaft (Fig, 37).
Fig,33
SoWind cord in direction indicated (CW)leaving 6 in (15-20 cm)
accessto pull through holestrimmer head body {Fig.34)°
Fig3 7
Fig 34
_. ,,J
16 LEHR I ALL RIGHTS RESERVED 2008-2009
Loading ...
Loading ...
Loading ...