Loading ...
Loading ...
Loading ...
W415-1139 / B / 01.08.13
15
EN
6.2 HARD WIRE INSTALLATION
!
WARNING
ENSURE ALL POWER IS TURNED OFF BEFORE HARD WIRING THIS APPLIANCE.
If it is necessary to hard wire the appliance, a qualifi ed electrician may remove the cord connection, and wire
the appliance directly to the household wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In
the absence of local codes, the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRIC CODE in the United States.
A. Remove the cover plate from the right side of
the appliance by removing the two screws, as
shown in Figure 1.
B. Remove the wire connectors and strain
relief from the power cord. The power cord
may be discarded. Refer to Figure 3.
C. Take the new cover plate, supplied in the
manual bag. Punch out the 7/8" hole and
install a box connector through, into the
junction box. Snap the box connector clamp
onto the supply wires.
D. Using the wire connectors, connect the
common wires together, then hot wires, and
then the ground wires, refer to Figure 3.
E. Reinstall the new cover plate as illustrated in
Figure 2.
NOTE: Leave enough wire so that the appliance can be removed from the enclosure without
disconnecting the power supply.
Fig. 1 Fig. 2
Fig. 3
Loading ...
Loading ...
Loading ...