Loading ...
Loading ...
Loading ...
36 25CI425A/W, 25HI425A, 50CI425A/W, 50HI425A
Evaporator disassembly
Note: The upper bearing, lower bearing and auger
assemblies must be replaced as assemblies. The
bottom and top bearing assemblies cannot be eld
assembled to factory specications.
1. Disconnect power to ice machine.
2. Shut off water to ice machine.
3. Drain evaporator and oat tank.
4. Disconnect plastic tubing from evaporator
water inlet.
5. Remove top bearing insulation.
6. Disconnect vent and drain tube from nozzle.
7. Remove compression nozzle insulation.
8. Disconnect compression nozzle tubing and
reservoir overow tubing from secured clip.
9. Remove nut and upper vee-band coupling
from top of evaporator.
10. Lift top bearing assembly straight up with a
slight rotating motion and remove.
11. Remove ice compression loop located at top
ofauger.
12. Lift auger straight up and out of evaporator.
13. Remove nut and lower vee-band coupling
from bottom of evaporator.
14. Lift evaporator to clear bottom bearing
assembly.
15. Loosen hex head bolt in side of mounting
base with 5/16" wrench and lift lower bearing
assembly.
16. Remove condensate shield.
1 7. Remove four Allen head machine screws
holding mounting base to gearbox.
18. If replacing evaporator, remove compression
nozzle from evaporator port.
Fig. 26
AUGER 00124123
COMPRESSION
FLAKER COMPONENTS
LOOP 00124115
Loading ...
Loading ...
Loading ...