Follett 25HI425AS000 User Manual

Loading ...

25CI425A/W, 25HI425A, 50CI425A/W, 50HI425A 33

SensorSafe Board guide

LEDs, when illuminated, indicate the following: PWR

(board power), CLN (clean button pressed WTR and

WM outputs disabled), ICE (ice dispensing activated),

WTR (water dispensing activated).

Terminals: L1 (incoming power, hot), L2 (neutral

terminals), WTR (power terminal for water solenoid),

WM (power terminal for wheelmotor), CLN (terminals

for clean cycle switch).

Note: SOL terminal not used in 12 series dispensers.

Fig. 17

SOL

WTR

NEUTRAL

CLN

PWR

WTR

GND

ICE

Lens/sensor troubleshooting

1. Turn dispenser power switch off and remove slash panel.

2. Disconnect wires from WTR and WM terminals on board.

3. Gently remove sensor/mounting block from splash panel.

4. Inspect lens and sensor, clean if necessary.

5. Restore dispenser power and test sensor by passing hand in front of sensor.

6. If LED on board turns on, sensor is operational. Re-assemble dispenser.

7. If LED does not come on switch sensor leads on board and retest.

8. If opposite LED comes on – replace defective board.

9. If opposite LED does not come on – replace defective sensor.

Ice machine removal instructions

CAUTION!

§ Disconnect power to unit before putting hands or arms in storage area or attempting any repair or service to

equipment.

Fig. 18 – All models

1. Dispense all ice and remove front cover

(Fig.18).

Fig. 19 – All models

2. Remove splash panel (Fig. 19).

Loading ...

25HI425AS000 Follett