Loading ...
Loading ...
Loading ...
Getting Started
Setting Clock at Power Up
You will be prompted to enter the time of day in the event
of a power failure or when you first provide electric power
to your appliance.
° When your appliance is first powered up, 12:00 wiii flash
in the display.
Press CLOCK Q. Enter the time of day using the numeric
e
key pads and press START to set.
If an invalid time of day is entered, the control will triple
beep. Re-enter a valid time of day and press START. If
STOP is pressed your dock will start with the time set for
12:00.
Preheat Temperature Display
Once a cooking feature has been started, the control will
display the actual oven temperature while preheating. Once
the oven reaches the oven set temperature, only the oven set
temperature will be displayed.
The preheat temperature display is available with the
following cooking modes:
* Bake
* Conv Bake
° Cakes & Breads
The minimum temperature displayed is 100°F/38°C.
Setting Timer
The timer provided with the oven control serve as extra
reminders in the kitchen. When the time runs out the active
timer will beep, and "End" will be displayed.
The following time settings apply to the timers:
* Min. time: 1 minute
* Max. time: 11 hours 59 minutes
See example below to set the timer for 5 minutes:
I. Press TIMER SET/OFF
2. Enter 5 minutes
3. Press START
To cancel or end the timer, press the TIMER SET/OFF key
again.
NOTE: The timer(s) will not affect the cooking process.
Setting Oven Lockout
The Oven Lockout feature automatically locks the oven door
and prevents the oven from being turned on. It does not
disable the clock, Timer or the interior oven lights.
See example below to lock the oven.
To lock, press and hold OVEN LOCKOUT for 3 seconds.
To unlock, press and hold OVEN LOCKOUT for 3 seconds.
DOOR LOCKED will flash in the display until the door has
finished locking. Once the door has been locked the door
loci< indicator will turn on. DOOR LOCKED will then stay
displayed.
Do not attempt to open the oven door while the door loci<
indicator is flashing.
To Set Add | Minute Feature
The ADD 1 MINUTE pad is used to set the Add 1 Minute
feature. When the pad is pressed, 1 minute is added to the
Timer feature if this feature is already active. If the Timer
feature is not active and the pad is pressed, the Timer
feature wiii become active and wiii begin counting down
from 1 minute. For further information on how to set the
Timer feature see Timer instructions above.
15
Loading ...
Loading ...
Loading ...