Loading ...
Loading ...
Loading ...
Setting Surface Controls
Operating Single Radiant Surface Elements
I__ Radiant surface elements may appear to
have cooled after they have been turned off:. The glass
surface may still be hot and burns may occur if the glass
surface is touched before it has cooled sufflcienfly.
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on fop
of the range when if is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.
Do not aflow aluminum foil, empty glass/
porcelain cookware or any material that can melt to make
contact with the ceramic cooktop. If these items melt on the
cooktop they may damage the ceramic cooktop.
Figure ] - Location of Single Elements
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface
element.
2. Push in and turn the surface control knob in either
direction to the desired setting. Turn the knob to adjust
the setting if desired.
3. When cooking has completed_ turn the surface control
knob to OFF before removing the cookware.
important notes:
* For emcient cooking, turn off the element several minutes
before cooking is complete. This will aflow residual heat to
complete the cooking process.
The surface control knobs do not have to be set exactly
on a particular spot. Use the graphics provided as a guide
and adjust the control knob as needed. Each surface
element provides a constant amount of heat at each
setting. Refer to chart above for suggested power level
settings.
® Start most cooking operations on a higher setting and then
turn to a lower setting to finish cooking.
Radiant elements have a limiter that allows the radiant
heating element to cycle on and off:, even at the HI
setting. This helps prevent damage to the ceramic smooth
top. Cycling at the HI setting is normal and will occur
more often if cookware is too small for the radiant
element or if the cookware bottom is not fiat.
® A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
I OFF LO 2 3 4 MED 6 7 8 Hi
Figure 2 - Single Surface Element Control Knob
I OFF WARM & 2 3 4 MED 6 7 8 TURBOSIMMER BOlL
Figure 3 - Turbo Boil Flex Surface Element Control Knob
11
Loading ...
Loading ...
Loading ...