Loading ...
Loading ...
Loading ...
REPAIR & ADJUSTMENT
5. Motion Drive Belt Replacement
The tractor drive belt may be replaced without tools°
Park the tractor on level area Engage parking brake,
NOTE: BELT INSTALLATION DECAL UNDER LEFT
FOOTREST.
am Remove mower. (See page 24).
b Remove two retainer springs from belt guide
bracket below transaxie pulley, Remove bracket
(Fig 31)
c Swing belt guides away from belt, toward rear of
tractor {Fig_ 3 I)
d, Roll belt over top of transexle pulley
e. Roll belt over engine pulley and off idler (Fig_ 33),
f . Release parking brake.. Pull belt as far as possible
over top of clutch pulley
g. Reset parking broke. Pull belt over top of clutch
pulley {Fig 33)
BELT
SHIFT GATE
ENGINE
PULLEY
FIGURE 32
h, Pull bett out through shift gate to remove from
tractor {Fig. 32},
Install belt by reversing above procedure.
NOTE: REPLACE ONLY WITH BELT LISTED IN
MANUAL.
CLUTCH
PUL
DRIVE BELT
SCHEMATIC
6, Hood Removal
a, Lift hood. Disconnect headlight wiring connection
iFig. 35L
b, Urrscrew one screw at rear of eash side panel {Fig,
34),
c. Pivot hood and sidepanel forward and lift off trac-
tor {Fig° 35).
d, To replace, reverse the above procedure,
BELT
TRANSAXLE
PULLEY
f I
RETAINER BELT GUIDE RETAINER
SPRING BRACKET SPRING
FIGURE 31
L H, SIDE
23
REAR
VIEWED FROM BOTTOM OF TRACTOR
FIGURE33
FIGURE 34
Loading ...
Loading ...
Loading ...