Loading ...
Loading ...
Loading ...
Alignment (Adjustments) (continued)
Dust B|ower
The dust bto_er wilt direct air to the most
effective point on the cutting tine when
the hold:down is adjusted. No adjust-
ment is necessary to the blower.
Blade Guard
The blade guard will always be posi-
tioned parallet to the blade, No adjust-
ment is necessary.
Mounting the Scroll Saw
Workbench Applications
• When mounting this saw to a work-
bench a solid wood bench is preferred
over a plywood bench where noise and
vibration will be more noticeable.
• Hardware to mount this saw to a work-
bench is not supplied with the saw.
However, we recommend the hardware
used be not smaller than the following,
Description Qty,
Hex Head Screw,
1/4-20 x Iength required .................. 3
Flat Washers, 1/4 I,D .......................... 6
Lock Washers, 1/4 I.D ......................... 3
I_ex Nuts, 1/4-20 ................................. 6
°A soft foam pad to place between your
scroll saw and workbench is not sup-
plied with the saw. However, we highly
recommend the use of such a pad to
reduce noise and vibration.
Description Qty.
Soft foam pad such as carpet
padding, 24" x 12" x 1/2", .................. t
Do NOT over tighten mounting bolts -
leave some cushion in the foam pad for
absorbing noise and vibration.
NOTE: Through normal use sawdust
accumulates under the unit, Frequently
clean sawdust from under the unit to pre-
vent the linkage from binding, which
could overload and damage the motor.
Legset Applications
1. ]f you prefer to mount your saw to a
leg set, we recommend the leg set for
bench top tools which is available
through Sears Retail Stores. The
number of this leg set is 9_22244.
This leg set is an optional accessory
and instructions to mount the scroll
saw to this leg set are included in the
leg set package.
18
Dust Blower/"
ill
Blade Guard
Scroll Saw Base"-_ TopView
Hex Head Screw_
Hex Head
Flat Washer.
1/2" Foam Pad
(Optional)
Flat Washer
Nut
Loading ...
Loading ...
Loading ...