Loading ...
Loading ...
Loading ...
m
• Determine which rear corner is rocking.
• Remove toe grille to gain access to roller adjustment
screws.
• Turn roller adjustment screw clockwise to raise corner
that is rocking.
_ screws
Rear roller i _ (
adjustment\[
screw\'/
Front roller_/
adjustment
screw
Check alignment of top of doors. If doors are level
replace toe grille.
If tops of doors are not level perform the following steps:
• Determine which door must be raised (if toe grille has
not been removed, remove at this time).
• Turn front roller adjustment screw clockwise to raise front
corner of door that needs to be raised. Roller adjustment
screw should be turned until doors are level.
• Replace toe grille.
Turn roller adjustment" "_ t
screw clockwise to
raise door
_"_ Turn_Ocller _di ustu_i? t
doors are level
Removing Handles
Tools Required
Putty knife (blade covered by masking tape)
5/I6"(8 mm) hex nut driver
3/8"(9.5 mm) hex nut driver
Phillips screwdriver
Blade screwdriver
WARNING I
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to refrigerator
before removing doors. After replacing doors, connect
power.
Some installations may require handle removal to get the
refrigerator into the home. If so, perform the following:
• Pry up edge of handle trim using a putty knife, with the
blade end covered in masking tape. Remove handle from
door by removing 2 mounting screws at each end of
handle.
Handle
trim Handle
/
trim
Removing Doors
Some installationsmay require door removal to get the
refrigerator into the home. If so, perform the following
steps:
1. Remove toe grille.
2. For ice and water dispensing units only.
Loosen water tube clamp screw. Loosen plastic water
tube union nut. Pull water tube away from union nut
and through tube clamp.
Plastic water tube
union nut
Water
tube screw
3. Remove top hinge screw by removing hinge cover
screw with a Phillips screwdriver.
Top
cover
Loading ...
Loading ...
Loading ...