Loading ...
CONTENTS
Safety ................................................................................... 2
Pump Performance/General Information ........................... 3
Before You Start/Tools/Materials ........................................ 4
Installation
Piping .................................................................... 4-5, 8-12
Electrical ........................................................................ 6-8
Helpful Hints ................................................................. 11-12
Parts .............................................................................. 13-15
INTRODUCTION
Please take a few minutes to read our instructions before in-
stalling your submersible pump. It vffll help to assure per-
fect installation and help you avoid needless service
expenses.
RULES FOR SAFE INSTALLATION AND OPERATION
Carefully read and follow all safety instructions in this man-
ual or on pump.
_1, This is the safety alert symbol. When you see this sym-
bol on your pump or in this manual, look for one of
the following signal words and be alert to the potential for
personal injury!
_ warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
[AWARNING] warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
[_ CAUTION ] warns about hazards that will or can cause
minor personal in jury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
To avoid risk of serious bodily injury and property
damage, read safety instructions carefully before in-
stalling pump.
1. _kWARNING Under certain conditions, submersible
Hazardous
pressure pumps can develop extremely high pres-
sure. Install a pressure relief valve capable
of passing entire pump flow at 75 PSI (517kPa).
_kDo not allow pump, pressure tank, piping, or
any other system component containing water
to freeze. Freezing may damage system, leading to in-
jury or flooding. Allowing pump or system compo-
nents to freeze will void warranty.
2. Follow local and/or national plumbing and electrical
codes when installing pump.
3. Keep well covered while installing pump to prevent
leaves and other foreign material from falling into well,
contaminating the well and possibly damaging the pump.
4. Protect pump and piping system from freezing. Allowing
pump or water system to freeze could severely damage
pump and voids warranty.
5. To protect system against over-pressure, install a pressure
relief valve (Stock No. 2729).
6. With a new well, test well water for purity before using.
Constflt your local Health Department for procedure.
LAWARNING[Hazardous voltage. Can shock, burn,
cause death, or start fires.
7. Disconnect electrical power source before installing or
working on pump.
8. Use pump only in a well application.
9. Correct fusing, vdring and grounding are essential to
proper operation. See Page 6 for electrical instructions.
10. Line voltage and frequency listed on motor nameplate
must agree with line voltage and frequency of electrical
power supply.
11. Use of fuses or wire smaller than size recommended in
owner's manual can cause overheating, possible fires,
and will void warranty.
2
Loading ...
Loading ...
Loading ...