Loading ...
Loading ...
Loading ...
24
Hot Plate Ignition Failure
location and ambient conditions.
Before Leaving
water. DO NOT
of gas valves, burners and ignition.
please instruct the user on the correct method of
operation.
• In case the appliance fails to operate correctly
authorised service provider in your area.
The burner is installed on the oven base and is covered
by the bottom plate which must always remain in that
position during oven operation,
To adjust the primary air, is performed when the
burner is ignited, by adjusting the sleeve (B) and
the adjustments have been made.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
GAS CONVERSIONS
REPLACING THE INJECTORS
Our burners can be adapted to different types of gas by
simply installing the injectors suitable for the gas you
gives the burner nominal heat input, injector diameter
and operating pressure of the different gas types.
INSTRUCTIONS FOR THE INSTALLER
20
21
Injector replacement - Hob burners.
To change the injectors on the hob, remove the burner
Injector replacement - Oven burner.
will release burner and give access to the injector (C).
Unscrew injector and replace it. Replace burner and
replace screw (D).
After having replaced the injectors, it will be
necessary to proceed with burner adjustment as
explained in the previous paragraphs.
REPLACING THE ELECTRICAL COMPONENT
• The rear protection will have to be removed in order
to change the electrical heating elements, spit
motor, terminal board and power cable.
• If you have to change the power cable (see
TECHNICAL FEATURES paragraph), always keep
the earth wire longer than the phase wires and,
in addition, follow all the instructions given in
the “ELECTRICAL CONNECTION” paragraph.
• To change the oven lamp see the instructions
REPLACING THE OVEN LAMP paragraph.
as indicated in the paragraph «REPLACING THE
TAPS».
• To change the programming accessory, the
thermostat, the commutator and the warning lights,
remove the front panel by unscrewing the three
19A
Loading ...
Loading ...
Loading ...