Loading ...
Loading ...
Loading ...
9.Troubleshooting Tips
Before Calling for Service
Review the charts on the following pages may save you from calling for service.
Problem
Possible Causes What to Do
Dishwasher doesn't Fuse blown, or the
Replace fuse or reset circuit breaker. Remove any other
Technical
problems
start
water not pumped
from dishwasher
Suds in the tub
Stained tub interior
White film on
circuit breaker acted
Power supply is not
turned on
Water pressure is low
Door of dishwasher
not properly closed.
Kink in drain hose
Filter clogged
Kitchen sink clogged
Improper detergent
Spilled rinse-aid
Detergent with
colourant was used
Hard water minerals
appliances sharing the same circuit
with the dishwasher
Make sure the dishwasher is turned
on and the door is
closed securely.
Make sure the power cord is properly
plugged into the
wall socket.
Check that the water supply is
connected properly and
the water is turned on.
Make sure to close the door properly
and latch it.
Check drain hose.
Check the coarse filter
(see section titled " Cleaning The
Filter ")
Check the kitchen sink to make sure
it is draining well.
If the problem is the kitchen sink not
draining ,you may
need a plumber rather than a
serviceman for dishwashers.
Use only the special dishwasher
detergent to avoid suds.
If this occurs, open the dishwasher
and let suds evaporate.
Add 1 gallon of cold water to the tub.
Close and latch the
dishwasher, then select any cycle.
Dishwasher will drain
out the water at the first step.Open
the door after draining
is stop and check if the suds is
disappeared.
Repeat if necessary.
Always wipe up rinse-aid spills
immediately.
Make sure that the detergent is the
one without
colourant.
To clean the interior, use a damp
sponge with
General
problems
inside surface
There are rust
stains on cutlery
dishwasher detergent
and wear rubber
gloves.
Never use any other
cleaner than
dishwasher
detergent for the risk of
foaming or suds.
Loading ...
Loading ...
Loading ...