Loading ...
Loading ...
Loading ...
NOTE:
[ PX:P1-Intensive,P2-Normal,P3-ECO,P4-Glass,P5-Daily,P6-Rapid,P7-Soak]
Change the Program...
Premise:
1
2
A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the
detergent may have already been released, and the appliance may have
already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section
entitled " Loading the
Detergent " ).
Press the Start/Reset button,the machine will be instand by state,press
the Start/Reset button more than
3s then you can change the program to the desired cycle setting (see the section entitled " Starting a wash
cycle. . ." ).
3
The LED display shows the state of the dishwasher:
a)The Screen shows PX and the left time blinking,if the left time is more than 1hour ,the hour and minutes are
alternately blinking
b)The Screen shows the delayed time, the point "." that behind of the time is biinking.
NOTE:
If you open the door during a wash cycle , the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected
program after the power cut
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1
2
3
Open the door a little .
After the spray arms stop working,
you can open the door
completely.
Add forgotten dishes.
4
5
Close the door
Press the Start/Reset Button, the
dishwasher will run
after 10 seconds.
At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the On/Off Button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Loading ...
Loading ...
Loading ...