Loading ...
Loading ...
Loading ...
4.Prior using for the first time
Before using your dishwasher for the first time:
A. Set the water softener
B. Add 1.5Kg dishwasher salt and then full fill the salt container with water
C. Fill the rinse aid dispenser
D. Fill in detergent
A. Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have
a detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority
can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of
the water used. This is intended to optimise and customise the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Switch on the appliance;
2. Press the Programme button formore than 5 seconds to start the water
softener set model within 60seconds after the appliance was
switched on;
3. Press the Programme button to select the proper set according to
your local environment, the sets will change in the following
sequence: H3->H4->H5->H6->H1->H2;
4. Press the On/Off button to end the set up model.
Note:1
O O O
O
O
dH:
fH:
German degree
French degree
O
Clark: British degree
Note:2
The manufactory setting: H3 (EN 50242)
Contact your local water board for information on the hardness of your water supply.
NOTE:
If your model does not have any water softener, you may
skip this section.
WATER SOFTENER
Loading ...
Loading ...
Loading ...