Loading ...
Loading ...
Loading ...
Page. 9
Preparing for STAR
®
burner orifice
conversion
To prepare the 7 mm, 9/32'' socket, or ¼'' nut driver for
STAR burner orifice replacement
1. Trim a small piece of the foam tape provided with this
kit to about 1/4 – 1/2'' (6 – 12 mm).
2. Place foam tape over the edge of a 7 mm or a 9/32''
socket, or with 1/4'' nut driver used to replace the
burner orifices, as shown below.
• The foam tape helps to retain the orifice in the
end of the nut driver so it will not fall inside the
appliance during orifice removal or installation.
To replace the front STAR burner orifices
1. With the foam tape wrapped nut driver, reach down
through the jet holders and remove the gas orifice
from the STAR burner’s jet holder.
2. Label each of the removed orifices, noting from which
burner they were removed, in the event the appliance
is converted back.
For your convenience, note the orifice sizes and
locations in the following table.
3. Locate the proper STAR burner
orifices included with the kit.
Orifices are stamped with the
orifice diameter size on the side.
4. Replace orifices as indicated in the table below.
Ensure the orifice is completely seated and tight to
the jet holder to avoid possible gas leaks.
NOTE: All of the replacement orifices in the conversion kit
have straight threads (not pipe threads) and do not
require thread sealing compound.
Changing the broil orifice, for
converting propane (LP) gas
units from 10,000 ft to 10,200
ft. only (12025444 kits)
9 CAUTION
After the replacement of the broiler orifice, and
before reassembly of the back panel and backguard to
the range, perform a brief gas leakage check of the
orifice and associated fittings, per the “Checking for
gas leaks” section of these instructions.
Removing the backguard assembly
1. Move the range out of its installed position to gain full
access to the rear panel of the backguard assembly
and to the broil burners' orifices.
2. Use a T-20 torx screwdriver to remove the screws from
the front of the backguard assembly.
Burner location Orifice size
Left front
Center front
Right front
All rear burners remain unchanged
1
2
36'' and 48'' Pro Harmony, LP units Orifice no.
All front STAR
®
burners only
1.26 mm (126)
All rear STAR burners remain unchanged
Loading ...
Loading ...
Loading ...