Loading ...
Loading ...
Loading ...
Page. 12
Removing the kick and front panels
1. Remove the kick panel screws using a T-20 torx
screwdriver.
2. Remove the front panel screws using a T-20 torx
screwdriver.
Changing the main oven bake burner
orifice
IMPORTANT:
• Do not bend the bake burner tube.
• Do not bend the bake burner gas tube.
• Do not modify the shutter opening. The air shutter
should remain fully open.
• Do not remove the anti-rotation bracket when
performing the orifice change. This bracket is
critical to the alignment of the bake burner tube
with the burner orifice. After the orifice
replacement, this bracket will facilitate the burner
tube’s realignment.
1. Remove the bake gas line using a 13/16'' box end
wrench.
2. Remove the two screws from the bake burner tube
mounting bracket with a T-20 torx driver.
4. Replace the orifice as indicated in the table.
5. Ensure that the bake orifice is aligned to the center of
the burner tube inlet. Reinstall the bake burner tube
beneath the oven. If necessary, use a flashlight to aid
in seeing the locating slot where the burner tube sits
at the backside of the burner cavity.
6. Slide the elbow fitting back into the anti-rotation
bracket. Reattach the two bake burner mounting
bracket screws and tighten the gas line.
7. Perform a gas leakage check of the orifice and
associated supply tube fittings per “Checking for gas
leaks” on page 13.
a. Anti-rotation bracket b. Bake gas line
c. Elbow fitting d. Shutter
e. Bake burner tube
mounting bracket
f. Bake burner tube
3. Insert a 1/2'' offset
wrench into the
shutter opening to
restrain the bake
orifice while hand
twisting the orifice
elbow
counterclockwise.
36'' and 48'' Pro Harmony Orifice no.
Main oven bake burner only 2.06 mm (206)
a e f
cb
d
Loading ...
Loading ...
Loading ...