Loading ...
Loading ...
Loading ...
Page. 8
Installation procedure
Changing the STAR
®
burner
orifices for converting propane
gas units from 10,000 ft. to
10,200 ft. (12025444 kits)
Disassembling the rangetop
9 CAUTION
Before proceeding, shut off the gas supply to the
appliance prior to disconnecting the electrical power.
Disconnect the appliance from electrical power by
unplugging the electrical cord from its receptacle or
by disconnecting power at the circuit breaker box.
To disassemble the rangetop
1. Remove the rangetop grates and the burner caps.
2. To facilitate the removal of the spill tray, remove the T-
20 torx screws in the front face of the island trim or
backguard.
3. Use a 16 mm hex head bit or Allen wrench to remove
the burner venturi from each burner base.
TIP: If a 16 mm hex head bit is not readily available, a
5/8'' hex bit can be selected. Alternatively, a bolt with
5/8'' head either “double-nutted” or tightened into
the chuck of a power driver can be used.
4. Disconnect the igniter. Carefully pull up on the burner
base.
5. Remove the screw securing the burner pedestal with a
T-30 torx driver. Carefully remove each burner
pedestal.
6. Remove the spill trays by pivoting the trays up and out
the back.
7. Remove the heat shield on some models. Some
models have a double-width shield that extends under
adjacent spill tray.
a. Grate
b. Burner cap
c. Venturi
d. Burner base
e. Electrode
f. Burner pedestal
g. Spill tray
h. Heat shield
i. Igniter housing
j. Igniter wire
d
b
a
e
f
g
h
c
i
j
a. Hex head bit or Allen wrench b. Burner venturi
1
2
a
b
Loading ...
Loading ...
Loading ...