Loading ...
Loading ...
Loading ...
Thisunitisputintorecordingpauseapprox.0.6secondsaftertheLCDmonitorisreopened
ortheviewfinderisextended.
• When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
• Start time will not be shortened if there is no SD card inserted.
(HDC-TM7001
Start time will be shortened if the [Built-inMemory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
Start time will be shortened if the [HDD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
• Change the mode to I_ or O.
1 Set [QUICK START] to [ON].
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or O,
The status indicator O flashes green and the unit
goes into Quick start standby mode.
• The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator O lights red and the
unit is put into recording pause.
• Quick Start Standby Mode is canceled if
about 5 minutes have elapsed
mode is set to []
• Time for Quick start will be more than 0.6 seconds slower when the Digital cinema is used.
• Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
• It may take some time for Automatic white balance to adjust.
• In the Quick Start Mode, the zoom magnification becomes 1 x.
• If [ECONOMY] (-) 47) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
• Turn the unit off using the power button.
• Quick start standby mode cannot be released by the remote control.
Please refer to page 53.
48
VQT2M75
Loading ...
Loading ...
Loading ...