Loading ...
Loading ...
Loading ...
WIRING
12
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
GREEN and WHITE wire connections on the
opposite side of the outlet box from the BLACK and
BLUE wire connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
2.
CC
CC
2
CC
3
Gently slide remote control receiver (N) flat-side
up into mounting bracket (C). Turn spliced/taped
wires upward and gently push wires and wire
connectors (CC) into outlet box. Let antenna from
remote control receiver (N) hang to the side.
NOTE: The remote control included with this fan
meets the following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz;
motor amps:1 MAX.
Should you choose to use a different remote
control with this fan, it must also meet these same
requirements.
3.
Antenna
A
N
C
1.
Lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws (G) in mounting bracket
(C). Twist canopy (B) clockwise to lock. Re-insert
the two canopy mounting screws (G) previously
removed (Step 4a, page 6) and tighten all canopy
mounting screws (G) securely.
FINAL INSTALLATION
1
B
D
G
D
B
Downrod
Option
Closemount
Option
G
Loading ...
Loading ...
Loading ...