Loading ...
Loading ...
Loading ...
E-16
Listening to the radio
1
2
3
4
5
4
5
3
2
1
OPEN / CLOSE
TUNING
PRESET
USB
AUDIO IN
AUDIO IN
USB
PHONES
TAPE
TUNER
CD
TIMER
ON/ STANDBY
(BAND)
VOL.
VOL.
REMOTE
SENSOR
OPEN / CLOSE
T
APE
TUNER
(BAND)
PRESET
TUNING
RRMCGA397AWSA
■ Tuning
1 Press the ON/STANDBY button to turn the power on.
2 Press the TUNER (BAND) (TAPE) button repeatedly
on the main unit or TUNER (BAND) button repeatedly
on the remote control to select the desired frequency
band (FM or AM).
3 Press the TUNING ( or ) button to tune in to the
desired station.
Manual tuning:
Press the TUNING (
or ) button as many times as
required to tune in to the desired station.
Auto tuning:
When the TUNING (
or ) button is pressed for more
than 0.5 seconds, scanning will start automatically
and the tuner will stop at the rst receivable broadcast
station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING (
or )
button again.
To receive an FM stereo transmission:
● Press the TUNER (BAND) button to display the “ST”
indicator.
● “
” will appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER (BAND)
button to extinguish the “ST” indicator. The reception
changes to monaural, and the sound becomes clearer.
■ Memorizing a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
1 Perform steps 1 - 3 in “Tuning”.
2 Press the MEMORY
button to enter the
preset tuning saving
mode.
3 Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY button to
store that station in memory. If the “MEMORY” and
preset number indicators disappear before the station
is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorized for that
preset channel number will be erased.
Note:
The backup function protects the memorized stations for
a few hours should there be a power failure or the AC
power cord become disconnected.
■ To recall a memorized station
Press the PRESET ( or ) button for less than 0.5
seconds to select the desired station.
■ To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1 Press the PRESET ( or ) button for more than
0.5 seconds. The preset number will ash and the
programmed stations will be tuned in sequentially, for
5 seconds each.
2 Press the PRESET ( or ) button again when the
desired station is located.
■ To erase entire preset memory (In TUNER
function)
Press and hold CLEAR button until ‘TUNER CLEAR’
appears.
Loading ...
Loading ...
Loading ...