Loading ...
Loading ...
Loading ...
f..._
.E
Row to Adjust the GaugeWheels
Theaxle bolts for the gauge wheels were mounted in the
LOWcut position. To changethe position of the gauge
wheels, move the axlebolts as follows.
IMPORTANT:Beforeyou adjust the gaugewheels,you must
do the following. Make surethe mower deck is level. Make
sure the height of cut is set at the heightyou want for your
lawn. Mow a short distance on a flat levelareaand look at
the areathat was cut. If the mower deck does not cut level,
seethe instructions "How To LevelTheMower Deck."
WARNING:Beforeyou make an inspection,
adjustment,or repair to the unit, disconnectthe
wire tothe sparkplug. Removethespark plugwire
to preventthe enginefrom startingbyaccident.
1. Removethe gauge wheels (Figure36).
2. Mow a short distanceon a flat level areato check the
level of cut and the height of cut. Lookat the height of
cutposition numberon the decklift lever (Figure37).
3. Look at eachgauge wheel bracket.Thereare 3 holes
in eachbracket and a number next to eachhole. The
number for the height of cut position on the decklift
lever indicatesthe correct hole to useon eachgauge
wheel bracket(Figure38).
4. Assemblethe axle bolts to the gauge wheel brackets
using the correct hole in the bracket as indicated
(Figure 38).
NOTE:If the height of cut position is changedby the deck lift
lever, you must move the gauge wheels to the correct hole
(Figure38) to keepa levelheight of cut.
©
@
Figure36: Gaugewheelassembly
A - Locking ring
B - Washer
C - Axle bolt
D - Gauge wheel
Figure37: Decktiff lever
A - Deckrift lever
B - Cutting height positions
1
2
3
©
1
2
3,4,5,6
Figure38: Gaugewheelbracketpositions
A - Gaugewheelbracket
B - Wheelbrackethole no.
C- Lift leverposition no.
Howto Level the MowerDeck
If the mower deck is level,the bladewill cut easierandthe
lawn will look better.
WARNING:Beforeyou makean inspection,
adjustment,or repair to the unit, disconnectthe
wire tothe sparkplug. Removethesparkplug wire
to preventthe enginefrom startingbyaccident.
1. Make sure the unit is on a hard flat surface.
2. Checkthe air pressure in the tires. If the air pressure is
incorrect, the mower housing will not cut level. Make
sure the tires are inflated to 14 PSI (1 BAR).
IMPORTANT:Onmodels equipped with gauge wheels,the
gaugewheels must be removed to correctly adjust the level
of the mower deck.
32
English
www.snapper.com
Loading ...
Loading ...
Loading ...