Loading ...
Loading ...
Loading ...
Installation Instructions
REVERSE OSMOSIS ASSEMBLY
MOUNTING SYSTEM INSTALLATION
Choose a location under the sink to mount the
system. Location should be easily accessible, with
adequate clearance between the bottom of the
filter cartridges and the floor or bottom of the
cabinet for removal of filter cartridges. Allow
enough space on either side of the system for the
tubing connections.
1. Remove the prefilter and postfilter cartridges.
2. Remove the assembly cover by unlocking the
four tabs on the cover from the system.
To remove To remove
Prefilter _ _ Postfilter
3, Use a flat-head screwdriver to work from left to
right from the underside of the system.
4, Use the icons on the bottom of the system for
screwdriver positioning.
Screwdriver positioning
System openinc Screwdriver
S,
Hold the Reverse Osmosis assembly up to the
wall surface where you wish to install it. Hark
location for screws. There should be a
minimum of 17" from the marks to the bottom
of the cabinet floor.
Screw locations
IMPORTANT - Do not get dirt or debris
inside the assembly area. Use only to mark
mounting hole locations.
6. Install screws to the wall, leaving a 3/16"
clearance between the head of the screw and
wall (drill pilot holes if needed).
,
,
,
lO,
\ Wall
\
\
\
\
\
\
\
\
Hang the Reverse Osmosis assembly on the
screws. Tighten or loosen the screws as desired
until the system is secure on the wall.
To install the _._-_._...... .....
tabsfrontopen,ngscovercover,line up theonwiththethe _ ....:_lm- _--
in the system.
Snap the cover
in place; the tabs
will flex, allowing
the cover to
snap in place.
Remove the
membrane
cartridge.
Membrane
To remove
9
Loading ...
Loading ...
Loading ...