Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
Electrical connection
This appliance must be supplied with a 220–240V, 50Hz, sinusoidal, 10Aelectrical
supply.
Check the power cord for damage, making sure it is not squashed or twisted.
A damaged power cord must be replaced by a Fisher & Paykel Authorised Repairer, in
order to avoid a hazard.
The appliance must not be operated until it is repaired, as there is a risk of electric shock.
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which
may affect how your washer works or may cause flooding.
In multi-storey apartments or any upper floor, the washer should be installed on a floor
equipped with a drain.
Draining must comply with local by-laws.
Water supply
IMPORTANT!
Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
Temperatures above these may cause the washer to fault or cause damage to the
washer.
If you have an uncontrolled water heating source (eg a wet back or solar heating
system) you should fit a tempering valve. This will ensure the hot water temperature
remains within safe limits.
Contact your registered plumber to select and install the tempering valve.
Inlet water static pressure: Max.1MPa(150psi) Min.34KPa (5psi)
Inlet water flow rate at tap: Min.6litres/min
IMPORTANT!
This appliance must be installed in accordance with the installation instructions
before use.
Provide accessibility to the plug or incorporate a switch in the fixed wiring in
accordance with the wiring rules to allow disconnection of the appliance from the
supply after installation.
Do not operate this washer if it has been damaged during transport. Contact your
Fisher&Paykel dealer or Fisher&Paykel Authorised Repairer.
Loading ...
Loading ...
Loading ...