Loading ...
Loading ...
Loading ...
4
ABOUT YOUR WATER HEATER
WATER HEATER APPLICATION
This water heater is designed for use in a single family domestic dwelling for the purpose of heating potable
water. Its use in an application other than this may shorten its life.
MODEL TYPE
The Rheem
®
continuous flow gas water heater model you have chosen is for outdoor installation only.
The water heater has a maximum preset outlet temperature setting of:
874 series 75°C
876 series 50°C
Notes:
The 876 series water heater is marked “THIS APPLIANCE DELIVERS WATER NOT EXCEEDING 50°C
IN ACCORDANCE WITH AS 3498” on the front panel. This model;
must not be installed as an in-series gas booster to a solar water
heater, as water temperature greater than 50°C can be delivered
from the water heater contravening its compliance to AS 3498.
The 874 series water heater may be installed as an in-series gas
booster to a solar water heater. For information relating to the function
and operation of the solar water heater, refer to the Owner’s Guide and
Installation Instructions supplied with the solar water heater.
When installed as an in-series gas booster to a solar water heater, the
874 series water heater:
can deliver water at temperatures up to 70°C to 80°C for a Premier
Loline and Loline pumped system and a Hiline thermosiphon
system and possibly higher temperatures from a Premier Hiline
thermosiphon system.
during periods of low solar energy gain, will boost the water
temperature automatically to its preset outlet temperature setting.
MAINS PRESSURE
The water heater is designed for direct connection to the mains water supply. If the mains supply pressure in
your area exceeds that shown on page 48, a pressure limiting valve must be fitted. The supply pressure should
be greater than 120 kPa for the rated flow and performance to be achieved.
WATER HEATER OPERATION
The water heater operates automatically, heating water as it passes through the water heater. When a hot tap
is opened, the gas burners ignite to provide immediate heating of the water. The heat produced by the burner
is transferred to the water through the heat exchanger. The water is heated to a constant temperature by the
automatic adjustment of the gas supply to the burner to suit the water flow rate (refer to “Temperature Control”
on pages 11 to 40). The gas burners extinguish when the hot tap is closed.
Automatic safety controls are fitted to the water heater to provide safe and efficient operation.
REDUCED HOT WATER FLOW WHEN HEAT EXCHANGER IS COLD
At a cold start-up, i.e. when the water heater has not operated for some time (which is most often first thing in
the morning), the initial flow of hot water may be reduced for a period of 5-10 seconds while the heat exchanger
warms up. This is both an energy and water saving feature of this water heater. Once the heat exchanger
has warmed up the hot water flow will increase and remain at normal flow levels. This feature will only occur
at a cold start-up and not when the heat exchanger is already warm from a recent use of hot water.
Loading ...
Loading ...
Loading ...