Loading ...
Loading ...
Loading ...
3,
4,
Orient the Upright (2) and the Top Shietd Cover
(37) as shown., S_ide the Top Shield Cover
upward onto Ihe Upright,
Have a second person hold the Upright (2) near
the Frame (I).
See the Inset drawing. Locate the wire tie in
tl_e Upright (2) ]]e the lower end of the wire tie
to the Wire Harness (42), Next, pull the upper
end of the wire tie upward out ot the top o[ the
Uptight, Then, untie and discard ihe wire tie,
Tip: To prevent the Wire Harness (42) from
falling into the Upright (2), secure the Wire
Harness with a rubber band or a piece of
tape.
Slide the Upright (2) onto the Frame (!), Tip;
Have a second person hold the Top Shield
Cover (37) out of the way.
Tip: Avoid pinching the Wire Harness (42).
Attach fhe Upright (2) with four M!0 x 20mm
Patch Screws (79) and four Mt0 Split Washers
(Te).
Slide the Top St_ietd Cover (37) downward and
press it into the Frame (t)
Avoid pinching the
Wire Harness {42)
79
>79
7
Loading ...
Loading ...
Loading ...