Loading ...
Loading ...
Loading ...
56
W415-1678 / 08.09.16
EN
97.1A
Remove the backing of the logo supplied and place on the glass viewing
door, as indicated.
½"(12.7mm)
LOGO
½"(12.7mm)
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct fl ame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
TM
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER
TM
logs available
from your authorized dealer / distributor.
A. Before beginning installation, disconnect the gas and electrical power supply from the appliance.
B. Locate the battery housing supplied in the manual baggie.
C. Install four “AA” batteries (not supplied) into the battery housing, ensure the positive and negative
ends correspond with those identifi ed on the holder. (To open the battery housing, slide the back
piece upwards and off of the battery housing).
D. Remove the safety screen to easily access the control compartment.
E. Attach the wire labelled “BATTERY”
from the wiring harness, located in the
control compartment of the appliance,
to the battery housing.
F. Place the battery housing into the
control compartment, ensure that the
battery housing is placed in a clean
and easily accessible location.
G. Reinstall the safety screen. The safety
screen must be installed at all times
during the appliance operation.
H. Turn the gas and electrical power back
on to begin operating the appliance.
!
WARNING
ENSURE THE GAS AND ELECTRICAL POWER TO THE APPLIANCE IS TURNED OFF.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL THE APPLIANCE HAS COOLED.
NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
NOTE: Once the power has been restored,
remove the batteries from the holder. The
system will drain the batteries if they are left
in the battery holder.
RED WIRE
BLACK WIRE
BATTERY
HOUSING
CONTROL MODULE
32.1
Randomly place the charcoal embers along the
f
ront and sides o
f
the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
!
WARNING
CHARCOAL EMBERS, VERMICULITE AND CHARCOAL LUMPS ARE NOT TO BE PLACED ON THE
BURNER.
6.5 CHARCOAL EMBERS
6.6 GLOWING EMBERS
6.7 LOGO PLACEMENT
6.8 BATTERY BACK-UP INSTALLATION
Loading ...
Loading ...
Loading ...