Loading ...
Loading ...
Loading ...
STEP 2. Remove hold-down screw and STEP 4a. Place the hook-shaped end
terminal block cover, of the wire over the terminal block screv
The open side of the hook should face
Terminalblockcover H01d-d0wnscrew to the rig _t. Squeeze hook end of wire
/ I_ I _ together Loform a I,oo;.
outer terminal block screws using the
same method(s) described in STEP 4a.
STEP 3. Attach a 3/,-inch, U.L.-listed,
strain relief to the hole below terminal
block opening. Strain relief should have
a tight fit with laundry center cabinet and
be in a horizontal position. Put the direct
wire cable through the strain relief.
Securely l:ighten all electrical connections
STEP 6. Tighten the strain relief screws.
STEP 7. Insert tab of terminal block
cover into slot of the laundry center rear
panel. Secure cover with hold-down
screw.
STEP 4. Loosen or remove terminal block
screws. Connect the neutral wire (white
or center) of direct wire cable under the
center screw of the terminal block.
If local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire, see
the instructions on page 23.
Otherwise, proceed with Installation
on page ;.>9.
Centersilver-colored
block screw
Neutral
wire
(white)
Neutralgrounding
wire(green/yellow)
3h-inch,
U.L.-listed,
strain relief
Externalground
connector
3-Wire Connection with Direct Wire
and Frame-Grounding Conductor
22
Loading ...
Loading ...
Loading ...