Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Models with Ceramic Glass Cooktop (cont'd)
Operating the Dual Surface Radiant Element
The cooktop is equipped with a dual radiant surface element located
at the right front (See Figure 4) position. "0 and @" on the control
knob are used to indicate which coil of the dual radiant element
will heat. "0" indicates that only the inner coil will heat (Figures
1 and 2). "@" indicates that both inner and outer coils will heat
(Figures 3 and 4). You may switch from either coil setting at any
time during cooking.
Figure 1 Figure 3
Figure 2 Figure 4
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See
Figure 1) for smaller cookware or clockwise (See Figure 3)
for larger cookware.
3. Turn the knob to adjust the setting if needed. Start most cooking
operations on a higher setting and then turn to a lower setting
to finish cooking. Each surface element provides a constant
amount of heat at each setting. A glowing red surface heating
area extending beyond the bottom edge of the cookware indicates
the cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface control knob
to OFF before removing the cookware. :::;:;
Note: The Surface Indicator light will come on when the control knob is turned on and will continue to glow until the glass .................
cooktop has cooled down to a moderate level. The light may remain on even though the controls are turned OFE
Note: See page 8, Figure 1 for recommended control settings.
To Operate Simmer Select Surface Element
The element control may be used as a normal element or as a simmer
element. The "Simmer Select" feature heats the element at a much
lower temperature than when used as a normal surface element. You
may switch between normal cooking and the Simmer Select feature at
any time during the cooking process. When using the element control
for normal cooking all of the settings on the control knob (LO to HI)
function as normal.
To Start Simmer Select:
1. Place correctly sized cookware on the radiant surface element.
2. Press the Simmer switch to ON located at right of the control knob.
3. Turn the surface control knob to the desired simmer setting within
the dark band on the control knob. Use the marks as a guide and
adjust the control knob as needed (see Figure 5).
,
S_MMER SELECT
ON
OFF
Figure 5
To return to normal cooking, press "Simmer Select" switch to OFE When cooking is complete, be sure to set the
control knob to the OFF position.
Using Turbo Boil TM Element
The Turbo BoilTMfeature uses a higher wattage surface radiant element
which can bring food items to boil much quicker. The left front radiant
element will be clearly marked if this feature is available on your range.
If equipped with the Turbo BoilTM feature, place the cookware on the left
front surface element and follow the instructions "To Operate a Single
Radiant Element" in the Settings Surface Controls section.
Figure 6
9
Loading ...
Loading ...
Loading ...