Loading ...
Loading ...
Loading ...
6
© 2021 United States Stove Company
NOTE: Connector pipe is not included. To purchase pipe,
visit your local Hardware, home or building center. See
“locating stove” for Additional specications.
1. Slide the lower end of the stove pipe into the ue
outlet collar as shown. Note: The crimped end of the
stove-pipe slides into the cast iron ue collar at top
rear of stove. Secure stove pipe to ue collar with at
least three (3) sheet metal screws and seal with stove
cement.
2. Horizontal pipe runs must slope upwards towards the
chimney at least 1/4” per foot of horizontal run.
3. You must have at least 18 inches of clearance between
any horizontal piping and the ceiling.
4. The pipe cannot extend into the chimney ue.
5. Secure pipe/elbow sections with three (3) sheet metal
screws at each joint to make the piping rigid. Secure
pipe/elbow sections with a minimum of three (3)
equally spaced sheet metal screws at each joint and
at the stove collar to make the pipe rigid.
6. It is recommended that no more than two (2) 90 degree
bends be used in the stove-pipe installation. The use
of more than two 90 degree bends may decrease the
amount of draw and possibly cause smoke spillage.
Where possible, use only corrugated (non-adjustable)
elbows. These provide a better seal.
7. The connector pipe must not pass through an attic or
roof space, trusses, closet, or any concealed space,
or oor, ceiling, wall or combustible construction (See
Chimney Connector Systems & Clearances) A UL 103
HT listed chimney system must be used from the rst
penetration of ceiling or wall to the chimney cap. Use
chimney components from a single manufacturer. Do
not mix brands.
CORRECT WRONG WRONG
Flue Outlet Collar
Stovepipe/Flue Connections
WARNING:
DO NOT USE SINGLE WALL CONNECTOR PIPE AS A
CHIMNEY - A HOUSE FIRE COULD RESULT.
CAUTION:
KEEP FURNISHINGS AND OTHER COMBUSTIBLE
MATERIALS AWAY FROM THE STOVE.
CORRECT WRONG WRONG
Stovepipe/Flue Connections
Hand-form pipe to oval shape
Flue Outlet Collar
INSTALLATION
Loading ...
Loading ...
Loading ...