Loading ...
Loading ...
Loading ...
© 2021 United States Stove Company
11
CAUTION: HOUSE FIRE HAZARDS
• GASSES EMITTED FROM FRESHLY ADDED COAL
MUST BE BURNED OR THEY WILL ACCUMULATE
AND EXPLODE. NEVER SMOTHER A FIRE WHEN
ADDING FRESH COAL.
• NEVER USE MANUFACTURED “COAL BRICKS”
MADE OF COAL DUST AND WAX-TYPE BINDER.
• DO NOT STORE COAL ON FLOOR PROTECTOR,
UNDERNEATH STOVE PIPE OR ANYWHERE WITHIN
MINIMUM CLEARANCES FROM COMBUSTIBLE
SURFACES SPECIFIED FOR THIS STOVE (36”)
• OVER FIRING MAY CAUSE A HOUSE FIRE. YOU
ARE OVER FIRING IF THE STOVE OR CHIMNEY
CONNECTOR GLOWS RED.
• BUILD FIRES ONLY ON INTEGRAL GRATE INCLUDED
WITH THE STOVE.
WARNING: EXPLOSION HAZARD
• NEVER USE CHEMICALS, GASOLINE, GASOLINE-
TYPE LANTERN FUEL, KEROSENE, NAPHTHA,
CHARCOAL LIGHTER FLUID, OR SIMILAR
FLAMMABLE LIQUIDS TO START OR “FRESHEN-
UP” A FIRE IN THE STOVE.
• KEEP ALL FLAMMABLE LIQUIDS, ESPECIALLY
GASOLINE, OUT OF THE VICINITY OF THE STOVE —
WHETHER IN USE OR IN STORAGE.
• DO NOT STORE COAL ON FLOOR PROTECTOR,
UNDERNEATH STOVE PIPE OR ANYWHERE WITHIN
MINIMUM CLEARANCES FROM COMBUSTIBLE
SURFACES SPECIFIED FOR THIS STOVE (36”)
• OVER FIRING MAY CAUSE A HOUSE FIRE. YOU
ARE OVER FIRING IF THE STOVE OR CHIMNEY
CONNECTOR GLOWS RED.
• BUILD FIRES ONLY ON INTEGRAL GRATE INCLUDED
WITH THE STOVE.
OPERATING SAFETY PRECAUTIONS
1. Stove is hot while in operation. Keep children, clothing,
and furniture away from hot stove. Contact may cause
skin burns. Do not touch the stove after ring until it
has cooled.
2. Never over re this stove by building excessively hot
res as a house/ building re may result. You are over
ring the stove if stove or stove pipe begins to glow or
turn red.
3. Never build extremely large res in this type of stove
as damage to the stove or smoke leakage may result.
4. Provide air into the room for proper combustion.
5. Inspect stove-pipe every 60 days. Replace immediately
if stove-pipe is rusting or leaking smoke into the room.
FOR USE WITH SOLID COAL FUEL ONLY
Chestnut, egg stove or nut-sized coal for residential
furnaces or any of the specialty packaged replace coals
(not wax-type “Coal Bricks”) can be used. Low ash content
(2% to 6%) coal is recommended.
NOTICE:
USE SOLID COAL MATERIALS ONLY. FOR BEST RESULTS
WHEN BURNING COAL, USE SOLID, BITUMINOUS
COAL. NEVER USE MANUFACTURED COAL “BRICKS”
MADE OF COAL DUST AND WAX-TYPE BINDER. STORE
COAL IN DRY, WELL VENTILATED AREA. DO NOT BURN
GARBAGE, CHARCOAL OR FLAMMABLE LIQUIDS SUCH
AS GASOLINE, NAPHTHA OR ENGINE OIL.
LIGHTING
1. Open ue draft damper fully to provide maximum
draft.
2. Remove lid(s) and place several wads of crushed
paper in the rebox.
3. Lay small stacks of kindling on the paper to start the
re.
4. Light the paper and kindling and replace the lid(s).
Make sure they are seated properly. Keep ash door
closed when stove is in use.
5. Add fuel after re is burning briskly. Use care not to
smother the kindling re when adding fuel. Replace
the lid(s) and make sure they are seated rmly.
6. Adjust the draft damper and spin draft control. The
more closed the spin draft is set, the lower and slower
the re will burn. The more open, the faster and hotter
the re will burn. Do not over-re the stove.
7. NEVER build extremely large res in this type of stove
as damage to the stove or smoking may result. If you
have too much draft, then regulate the draft with the 6˝
stove pipe damper.
8. DO NOT TOUCH – SEVERE BURNS MAY RESULT! After
ring DO NOT TOUCH STOVE until it has cooled.
9. Replace lid(s) and make sure they are seated properly..
10. This is a cast iron stove. It does NOT have welded
seams. From time to time you may need to “tune-
up” the stove by relling and/or replacing the stove
cement/ mortar along the seams.
OPERATING INSTRUCTIONS
Loading ...
Loading ...
Loading ...