Loading ...
Loading ...
Loading ...
4
© 2021 United States Stove Company
NOTICE: Vogelzang International Corporation grants
no warranty, stated or implied, for the installation
or maintenance of your coal stove and assumes no
responsibility of any incidental or consequential damages.
TOOLS REQUIRED
• Safety Glasses
• Hearth Gloves
• Pencil
• 6 foot Folding Rule or Tape Measure
• Tin Snips
• Drill: Hand or Electric 1/8” dia. Drill Bit (sheet metal
screws)
• Screwdrivers (blade and phillips types)
• 13mm Nut Driver or Ratchet with 13mm Socket (for
13mm Hex Nuts)
• 13mm Nut Driver or Ratchet with 13mm Socket (for
Stove Bolts)
MATERIALS REQUIRED
• Flooring Protection: 56˝ x 59˝ as specied Chimney
Connection: 6˝ black steel (24 ga. min.) straight or elbow
(as required)
• 1/2˝ Sheet Metal Screws
• Chimney: Existing 6˝ Code-approved,
• Lined Masonry Chimney or 6˝ Inside Diameter
manufactured chimney system listed to UL 103 HT.
• Furnace Cement (manufacturer recommends Rutland
Code 78 or equivalent)
CAUTION:
STOVE IS HEAVY. MAKE SURE YOU HAVE ADEQUATE
HELP AND USE PROPER LIFTING TECHNIQUES
WHENEVER MOVING STOVE.
Refer to diagram and parts lists at back of this manual.
1. Uncrate the stove and remove cardboard packing
and protective poly bag (save cardboard for further
assembly).
2. Remove parts from inside of stove. Parts include: four
lids (#1), three lid supports (#4 & #5), one ash door
(#14), one lid lifter (#16), four legs (#15), hardware
pack (#17), and Spring Handle (#12) and draft damper
(#18).
3. Place attened carton on oor and carefully turn stove
over onto carton.
4. Attach the legs to base of stove with stove bolts.
5. Carefully lift stove upright and place in desired location
(see following instructions for properly locating stove).
6. Place lid supports and four lids in position on stove
top.
7. Lower ash door into position.
8. The ue pipe draft damper (#18) must be installed into
the top end of the rst straight section of stove pipe
(gure1) exiting the stove before the stove is used.
a. Drill two 1/4” holes centered on either side of the pipe
section 6” from the top end of the pipe Remove the
handle from the damper then slide the damper into the
pipe.
b. Align the damper with the holes drilled in step 8a and
insert the handle through the holes and the damper.
NOTE: This damper is necessary for the proper operation
of the stove and to meet EPA emissions requirements for
heating appliances. It must be installed before use (No
exceptions)
9. Attach stove piping — see instructions.
6"/15.25 cm
Draft Damper
Installation
ASSEMBLY INSTRUCTIONS
Loading ...
Loading ...
Loading ...