Loading ...
Loading ...
Loading ...
16
BOTTLE, KEG & BACK BAR COOLERS, GLASS & PLATE CHILLERS
OPERATIONS MANUAL
CASTER ADJUSTMENT
If the height of a caster needs to be raised, shims must be
installed under the casters which need leveling (see Figure 15).
Extra-large washers, available at most hardware or furniture
stores, can be used to shim casters, or contact the factory for
caster shims.
Do not level casters by unscrewing them and leaving
them loose. This will damage the cabinet and threaded
holes, voiding your warranty.
LEVELING CABINETS WITH LEGS OR CASTERS
Your cabinet must be leveled correctly, front-to-back and side-
to-side, for proper operation. If it is not level, the condensate pan
in your cabinet will not drain properly and water may overflow
into the storage compartment.
IMPORTANT NOTE: It is extremely important that your
cabinet is perfectly level for proper operation. If it is not
level, the following adverse conditions may occur:
1. The door(s) will not be properly aligned and conse-
quently will not provide a good seal.
2. Your unit may run excessively.
3. An excessive amount of ice will accumulate in the
cabinet, around the door opening(s) and on the
evaporator coil. If allowed to continue, ice will eventu-
ally block the coil and the unit will fail. This can result
in loss of food stored in the cabinet.
4. Condensate water will fail to drain properly and will
overflow the evaporator coil drain pan and into the
storage compartment of the cabinet.
LEG ADJUSTMENT
All legs are equipped with bullet-type leveling feet (see Figure
14). Wood blocks may be used to support the cabinet, as shown,
so the bolts can be turned by hand or by wrench to level the
cabinet.
FIGURE 15: Leveling Casters
FIGURE 14: Leveling Legs
A
LEG
LEG INSTALLATION
BLOCKS
THREADED
END
TURN FOOT CLOCKWISE
TO REDUCE HEIGHT, OR
COUNTERCLOCKWISE
TO INCREASE HEIGHT.
A
OPTIONAL
CASTER SHIM
(CM1-2476)
CASTER
CASTER INSTALLATION
BLOCKS
04/29/10
Loading ...
Loading ...
Loading ...