Loading ...
Loading ...
Loading ...
20
A
C
B
4. If you are installing your keg refrigerator under a coun-
ter you will need to drill 5 holes in the counter top to
1
2" diameter hole
located at the center of the tower for the beer line, lo-
cate approximately 13
1
2
of the counter top (based on a counter top depth of
25
5
16-
mensions in Figure 38. The hole diameter is dependent
on the counter top material and if screw anchors are
required. The screws supplied are in the literature pack
and are a #10 x 1" type AB stainless steel screw. Mark
and cut the rectangular cutout for the drain sump. After
the holes are drilled and the keg refrigerator is in place
under the counter top feed the beer line through the
tower gasket, the 1
1
2" hole in the counter top and the
hole in the top of the keg refrigerator. Mount the tower
to the counter top with the 4 screws provided. Place
the counter top drain sump, from the literature pack, in
the rectangular hole with the radius cutout to the rear
around the tower and place the grate in the sump.
5.
Note that the regulator has left hand threads and has to
be turned counterclockwise to tighten. Tighten with the
adjustable wrench or the 1
1
8" open end wrench.
6.
largelarge
7. Connect the clear beer line from the tower to the small
small hose
8. Locate the gas tank in the corner of the refrigerator as
shown in Figure 41 and secure with the chain. Close
the faucet handle on the tower.
Diameter
to suit
Rear of counter top
6
1
8"
12
1
4"
2
7
8"
4
1
4"
6
3
8"
1
3
8"
typical
1
1
2
Diameter
counter
top depth
25
5
16"
1
4
radii,
typical
Figure 38
Figure 39
Figure 40
Grate from top of
beer dispenser
Counter top
sump from
literature pack
Tower
!
CAUTION
The cutout dimensions shown in Figure 38 are based on
a 25
5
16
-
sioning. Refer to the product dimensions on page 6 when
determining the required dimensions.
USING YOUR BEVERAGE DISPENSER
Loading ...
Loading ...
Loading ...