Loading ...
Loading ...
Loading ...
20
Cleaning and Maintenance
NOTE: Cleaning and maintenance operations must only be carried out when the oven is cool.
The appliance should be disconnected from the power outlet or turned off at your isolation
switch before commencing any cleaning process.
Cleaning the oven exterior:
Before starting to clean your oven, be sure that all control buttons are off and your appliance has cooled off.
Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enameled and painted parts of your
oven. Use cream cleaners or liquid cleaners, which do not contain particles. As these cleaners may damage the
surfaces, do not use caustic creams, abrasive cleaning powders, rough wire wool or hard tools. In the event of
any excess liquids spilling over your oven surface during cleaning, clean up immediately so as to prevent
possible damage to the enamel or metal surface. Do not use steam cleaners for cleaning the oven.
Cleaning the interior of the oven:
Make sure to unplug the oven before starting to clean it. You will obtain best results if you clean the oven interior
while the oven is slightly warm (the oven should not be operating). Wipe your oven with a soft piece of cloth
(e.g. dish cloth) dampened with warm soapy water after each use, rinse cloth in warm water then wipe oven
again and then finish by wiping with a dry cloth. For a complete cleaning process, use dry and powder type oven
cleaners, following the oven cleaning product’s instructions.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can detach the oven door. Every door hinge has a
locking rod, when it is close, door was fixed in place, then the door was not disassembly. If in order to remove
down door to open the locking rod, hinge will be locked and would not bite.
When the hinge not locked, it will have a big strength to close in sudden. Make sure locking rod
closed all the time, and insure it was open when remove the door.
Remove the door
Full open the door.
Fold up the right and left side of locking rod. (picture A)
Close the door until reach to stop step, hold on both left and right sides of the
door, then reclose the door, upward and downward and pull out the door.
Install the oven door
Accord to the opposite order of door disassembly
When install oven door, make sure both hinge plug into opening mouth directly.
Both sides of hinge rabbet must be fixed onto the hinge mounting hole on the
door.
When open the door, spread down locking rod(picture B)
If the door drop accidently or hinges shut up suddenly, do not push you hand in hinges. Please
call your after-sell department.
Loading ...
Loading ...
Loading ...