Loading ...
Loading ...
Loading ...
SAFETY RULES FOR CIRCULAR SAWS
_Keep hands away from cutting area and blade,, Keep your
second hand On the auxiliary handle or motor housing. If both hands are holding
the saw, the blade cannot cut them°
Z_ CAUTION: Blades coast after saw is switched off.
I,KEEP your body positioned to either side of the saw blade and not in direct
line with the saw blade. Kickback could cause the saw to jump backwards. (See
"Kickback What Causes It and Ways to Help Prevent It" on pages 16 and I7)..
2 DO NOT reach underneath the work. The guard cannot protect you from the blade
beneath the workpiece.
_When sawing through a workpiece, the lower blade guard
DOES NOT cover the blade on the underside of the workpiece (Pg. 14 Fig. 2).
ALWAYS keep your hands and fingers away from the cutting area.
3 CHECK lower guard for proper closing BEFORE each use. DO NOT operate the saw
if the lower guard does not move freely and close instantly. Never clamp or tie the
lower guard in the open position.. If the saw is accidentalfy dropped, the lower guard may
be benL Raise the lowerguard with tile retracting lever The guard isoperating properly
when it moves freely, does not touchthe blade or any other part in all angles and depths
of cut, and readily returns to the closed position.
4.CHECK the operation and condition of the lower guard spring. If the guard and the
spring are not operating properly, they MUST BE serviced before use. The lower
guard may operate sluggishly, due to damaged parts, gummy deposits, or a buildup of
debris DO NOT operate your saw until the damage has been repaired or replaced_
5.The lower guard should be retracted manually ONLY for making special cuts, such
as pocket or compound cuts, ALWAYS raise the lower guard by retracting its lever,
As soon as the blade enters the material, the lower guard MUST be released. For all
other sawing, the lower guard should operate automatically..
6 ALWAYS make sure that the lower guard is covering the blade BEFORE placing the
saw down on a work bench or floor. An unprotected moving blade will cause the saw to
walk backwards, cutting whatever is in itspath. Make note of the time it takes for the blade
to stop spinning after the switch is released
7 NEVER hold the piece being cut in your hands or across your legs. It is importantto
support the workpiece property in order to minimize body exposure, blade binding, or loss
of control.
8 HOLD TOOL by insulated gripping surfaces (handles) when performing an operation
where the cutting tool may contact hidden wiring or its own cord. Contact with a "live"
wire will make the exposed metal partsof the tool"live" and shock the operator..
9..ALWAYS clamp the workpiece securely so it will not move when making the cut.
I0. When ripping, ALWAYS USE a rip fence or straight edge guide. This improves the
accuracy ofthe cut and reduces the chance of the blade binding.
tl ALWAYS USE blades that have the correct size and shape (diamond vs, round) arbor
holes. Blades that do not match the mounting hardware of the saw will run erratically and
cause loss of control.
9
Loading ...
Loading ...
Loading ...