Loading ...
Loading ...
Loading ...
TO HELP MAINTAIN CONTROL cont.:
10. Squeeze the trigger switch to start the saw. ALWAYS let the blade reach full speed
before you begin the cut into the workpiece.
11 When making a cut, ALWAYS use steady, even pressure. Forcing the saw causes
rough cuts and could shorten the life of the saw or cause Kickback.
I2. After completing your cut, release the trigger switch and allow the blade to come to
a complete stop DO NOT remove the saw from the workpiece while the blade
ismoving.
_When sawing through a workpiece, the lower blade guard DOES
NOT cover the blade on the underside of the workpiece (see Fig. 3, page 15)=ALWAYS
keep your hands and fingers away from the cutting area, Any part of your body
coming in contact with the moving blade will result in serious injury,
MAKING CROSS CUTS AND RIP CUTS (Figs, 12 and 12a)
Z_ WARNING: ALWAYS clamp and support workpiece securely, ALWAYS
maintain proper control of saw, Failure to clamp and support workpiece and loss of
control of saw could result in serious injury,
I. ALWAYS use your saw with your hands positioned correctly (see Fig,.13)..
Line o! Cut
Fig. 12a 0° fndicator_
Z_ WARNING: ALWAYS maintain proper control of the saw to make sawing
safer and easier, Loss of control of the saw could cause an accident resulting
in possible serious injury.
2 When making cross or rip cuts, align your line of cut with the right side of the notch
by the 0° indicator.. (see Fig. t 2a)..
3. Since the thickness of blades varies, MAKE ATRIAL CUT in scrap material along the
guideline to determine how much, if any, you should offset the blade from the guideline
to allow for the kerr of the blade to get an accurate cut..
21
Loading ...
Loading ...
Loading ...