Loading ...
Loading ...
Loading ...
I
OOKTOP
]
ISuRFAOEOONTROLSI
CAUHON$=-
If flame should go out during a
cooking operation, turn the burner
off. If a strong gas odor is detected.
open awindow andwait five minutes
before relighting the burner.
• Besure all surface controls are setto
the OFF position prior to supplying
gas to the cooktop.
NEVER touch cooktop until it has
cooled. Expect some parts of the
cooktop, especially around the
burners, to become warm or hot
during cooking. Use potholders to
protect hands.
PII_OYLESS IQIIYIOI
Pilotless ignition eliminates the need for a
constant standing pilot light. Each surface
burner has a spark ignitor. When cleaning
around the surface burner use care. If
cleaning cloth should catch the ignitor, it
could damage it preventing ignition.
Ifthe surface burner does not light, check
if ignitor isbroken, soiled orwet. Ifclogged,
clean the small port beneath the ignitor
using straight pin.
SETTI NG TH E
1, Place a pan on the burner grate. [.To
preservethe grate finish, do not operate
the burners without a pan on the grate
to absorb the heat from the burner
flame.)
2. Push in knob and turn immediately
counterclockwise to the Lite setting
until burner ignites.
• Aclicking (:spark)sound will be heard
and the burnerwill light. All ignitors
on the JDG8130 will spark when any
surface burner knob is turned to the
/ire position. On the JGD8345, the
grill burner and center bay burners
will spark when the grill or any center
bay burner is lit. Both of the right hand
bay burners will spark when either
one is lit.
3. After ignition, turn knob clockwise to
desired setting.
• The ignitor will continue to spark
until the knob is turned past the
/ire position.
OPEIIYllG DUIIIG A
POWER IAILURE
1, Hold a lighted match to the desired
surface burner head.
2. Push in and turn the control knob
slowly to Lite.
3. Adjust the flame to the desired level.
Wh enl !ghting the S Urface b urne rs,}
be sure all of the controls ale inthe
OFF p0siti0n!Strike the mat@first
and hold !t in P0sition bdore turning
the knob to Lite:
[SUGGESTED H_T SETTINGS ]
The size and type of cookware will affect the heat setting.
Settinqs
Hi
Uses
Use Hi to bring liquid to a boil, or reach pressure in a
pressure cooker. Always reduce setting to a lower heatwhen
liquids begin to boil or foods begin to cook.
PORT BELOW IGNITOR
SURFACECONTROL
Use to turn on the i
surface burners. An ::{ !
infinitechoiceofheatsettings is available
from Lo to Hi. At the
Hi setting a detent or
notch maybe felt. The knobs can be set on
or between any of the settings.
/O
I
4
An intermediate flame size is used to continue cooking. Food
will not cook any faster when a higher flame setting is used
than neededto maintain agentle boil. Water boils at the same
temperature whether boiling gently or vigorously.
Use Le to simmer foods, keep foods warm and melt
chocolate or butter.
Some cooking may take place on the [e setting if the pan is
covered. It is possible to reduce the heat by rotating the knob
toward OFF. Be sure flame is stable.
Loading ...
Loading ...
Loading ...