Loading ...
Loading ...
Loading ...
Use clean, fresh, regular unleaded gasolinewitha
minimumof 85 octane. Do not mix oilwith gasoline. If
unleaded fuel is unavailable leaded fuel may be used.
IMPORTANT: It isimportantto prevent gum deposits
from formingin essentialfuel system parts such as
the carburetor,fuelfilterhose ortank duringstorage.
Also,experience indicatesthat alcohol-blendedfuels
(calledgasohol or usingethanolor methanol)can
attract moisture which leadsto separationand forma-
tion ofacids duringstorage. Acidic gascan damage
the fuel system ofan engine whilein storage. To avoid
engine problems, the fuel system shouldbe emptied
beforestorage of 30 daysor longer.Never use engine
orcarburetor cleaner productsinthefueltank or
permanent damage may occur.
I_ CAUTION: Never startpressure washer without I
!
water source turned on and connected to
I
pressure washer.Failure to do so willcause
pump damage.
To Start Your Pressure Washer
• Remove gas cap.
• Add unleaded gasoline, slowly,to fuel tank.
• Do not overfill.
• Squeeze trigger on pressurewasher wand to relieve
airpressurecaused byturningon the water.Water
will spewout ofthe gun ina thin stream. This will
make iteasierto startthe engine.
• Engage the safety latch on the spray gun. Thislocks
the triggerin place and keepsyou from accidentally
sprayinga highpressure stream.
SAFETY
.LATCH
• On the engine there is a choke/run lever. Place lever
to the choke position.
I "_..ml I o_1
• On the enginethere is a throttle control lever.Place
throttle to the rabbit position. Always start engine
with throttle in the rabbit (high speed) position.
• Connect garden hose to the water inletonthe
pressure washer. Tighten by turning counterclock-
wise.
PUMP
INLET
• Connect high pressure hoseto discharge on pump.
• Connect the garden hose to the water spout and turn
water supply on.
• Grasp the starter grip and pull slowlyuntil resistance
isfelt,then pullfirmly to start engine.
NOTE: If enginedoes not start rightaway,squeeze the
triggeron the gunto relieveairpressurecaused by
turningon the water.Water willspew out ofthe gun ina
thinstream. Thiswillmake iteasier to pullstart the
engine. Ifmore than five pulls,place choke level backto
runposition.
• When engine starts, gradually move choke lever to
RUN position.
• For hot engine restarts, make sure throttle is in the
rabbit (high speed) position and the choke lever is in
the RUN position.
• Grasp the starter grip and pull slowly until resistance
is felt, then pull firmly to start engine.
Loading ...
Loading ...
Loading ...