Loading ...
Loading ...
Loading ...
iiillll
CUSTOIVlE PO I ILITIES
iiiii ,,Hill Illl NIIIlI,N,ll,,I
SERVICE RECORDS
Fill in dales as you com-
plete regular service
Tighten All Screws and Nuts
i Check Spark Plug
Check Drive Belts
Lubricate Chute Control Flange
checkFue_
SCHEDULE
i ill II
Before After As Before Before
Each !first 12 Needed Storage Each
Use Hours Season
Drain Fuel
GENERAL RECOMMENDATIONS
=
The warranty on this snow thrower does not cover items
that have been subjected tooperator abuse or negligence.
To receive full value from the warranty, the operator' must
maintain the snow thrower as instructed in this manual
Some adjustments will need to be made periodically to
properly maintain your snow thrower'
All adjustments in the Service and Adjustments section of
this manual should be checked at least once each
seasorL
SNOW THROWER
AFTER FIRST USE
e Check for any loose or damaged parts after each
use_
13
e Tighten any loose fasteners
AFTER EACH USE
,,, ,,,,,,,,
LUBRICATION CHART
ii,,,,i i
O
O Run the machine to clear the auger of snow
@ Remove all snow and slush from the snow thrower to
prevent freezing of auger or' controls
LUBRICATION - AS REQUIRED
e Lubricate the flange on the discharge chute before
storage.
e See Lubrication Chart diagram for lubrication points
and type of lubricant
ENGINE
SPARK PLUG
e Clean the spark plug and reset the gap periodically
To service or replace spark plug, see To Replace the
Spark Plug paragraph on page 16.
e Make sure that the spark plug is tightened securely
into the engine and the spark plug wire is attached to
the spark plug
e If atorque wrench isavailable, torque plug to 18 to 23
foot pounds
ii illl,l,i ,ll i lll
SERVICE DATES
Lubricate chute control flangeĀ° Re-
move discharge chute and coat
flange with a clinging type grease
such as Lubriplate_
i ii IHIII llllll
Clean the area around the spark plug base before
removal to prevent dirt from entering the engine
..._..__CAR BURETOR
GH SPEED ADJUSTING SCREW(Close finger tight only)
BOWL DRAIN
FIG. 7
Loading ...
Loading ...
Loading ...