Loading ...
Loading ...
Loading ...
................................... N,= = H= == H,H
OPERATION
11111,1,1, Hi, H = ,1, , ,,,,,,,,,,,,,,,,, = 11 11=111,,,, , H =Hii=,,,,,,,,=,,,,=
PRIMERBUTTON RECOIL
\ STARTER ELECTRIC
HANDLE STARTERBUTTON
TO STOP ENGINE (Fig. 6)
O To stop the engine, turn the key to OFF and
remove key Keep key in a safe place, The engine
wil! not start without the key_
TO START ENGINE (Electric Starter)
Fig. 6
The snow thrower' engine is equipped with a 120 volt AC,
electric starter and recoil starter,, Before starting the
engine, be certain that you have read the following
information:
COLD START
@ Insert the key and turn ON
O Move the choke control to the FULL position
@ Connect the power cord to the switch box on the
snow thrower,
® Plug theother end of the power cord intoathree hole,
grounded 120 volt AC receptacle
Q Push the primer button while covering the vent holes
as follows: (Remove finger from primer button be-
tween primes)
Do not prime iftemperature is above 50°F,
Two times if temperature is 50°F to 15° F
Four times if temperature is below 15° F
O Push down on the starter button until the engine
starts, Do not crank for more than 10 seconds at a
time This electric starter is thermally protected If
overheated it will stop automatically and can be
restarted only when ithas cooted to a safe tempera-
ture (a wait of about 5 to 10 minutes is required),
• Disconnect the power cord from the receptacle first
and then from the switch box on the snow I
thrower
@ AS the engine warms up and begins to operate
evenly, move the choke control slowly to the OFF
position If the engine falters, return to 1/2 choke until
it runs smoothly, then move to OFF position_
NOTE: Allow engine to warm up for afew minutes before
using the snow thrower' as the engine will not develop full
power until it reaches operating temperature,
WARM START
O Be sure the choke isin the OFF position and pullthe
starter handle until the engine starts
@ Do not pdme a warm engine,. If the engine fails to
start, follow the Cold Start instructions above
KEY
VENTHOLE BOX
, H ,, ,H =
FIG. 6
=N 11,1,1,1,= ,1,
CAUTION:THISSTARTER ISEQUIPPEDWITH
A THREE-WiRE POWER CORD AND PLUG
AND ISDESIGNEDTO OPERATEON120VOLT
AC HOUSEHOLD CURRENTJ IT MUST BE
PROPERLY GROUNDED ATALLTIMES TOAVOIDTHE
POSSIBILITYOF ELECTRICALSHOCK WHICHMAY BE
INJURIOUS TO OPERATOR. FOLLOW ALL INSTRUC-
TIONS CAREFULLYASSET FORTH IN THE "TO START
ENGINE" SECTION,.DETERMINE THAT YOUR HOUSE
WIRING IS A THREE-WIRE GROUNDED SYSTEM. ASK
A LICENSED ELECTRICIAN IF YOU ARE NOT SURE. IF
YOUR HOUSE WIRE SYSTEM IS NOT A THREE-WIRE
SYSTEM, DO NOT USETHIS ELECTRIC STARTER UN-
DER ANY CONDITIONS., IF YOUR SYSTEM IS
GROUNDED AND A THREE-HOLE RECEPTACLE IS
NOT AVAILABLEAT THE POINTYOUR STARTERWILL
NORMALLY BE USED, ONE SHOULD BE INSTALLED
BY A LICENSED ELECTRICIAN. WHEN CONNECTING
120 VOLT AC POWER CORD, ALWAYS CONNECT THE
CORD TO THE SWITCH BOX ON THE ENGINE FIRST,
THEN PLUG THE OTHER END INTO THE THREE-HOLE
GROUNDED RECEPTACLE. WHEN DISCONNECTING
POWER CORD, ALWAYS UNPLUG THE END IN THE
THREE-HOLE GROUNDED RECEPTACLE FIRST..
H ,,=,,,,,, H,,,,,,,
TO STOP ENGINE (Fig. 6)
O To stop the engine, turn the key to OFF and remove
key, Keep key in a safe place The engine will not
start without the key
TO START THE ENGINE
(Recoil Starter) Fig. 6
Before starting the engine, be certain that you have read
and understood all the instructions on the preceding
pages
COLD START
O Insert the key and turn ON
@ Move the choke control to the FULL position
11
Loading ...
Loading ...
Loading ...