Loading ...
Loading ...
Loading ...
ASSEMBLY
BATTERY
BOX
LABEL
TERMI!
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
• Remove adjustment knob and flat washer secu ring seat
to card board packing and set aside for assembly of seat
to tractor.
Pivot seat upward and remove from the cardboard
packing. Remove the carboard packing and discard.
• Place seat on seat pan and assemble shoulder bolt.
Tighten shoulder bolt securely.
• Assemble adjustment knob and flat washer loosely. Do
not tighten.
• Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDER
BOLT ,_._.
ADJUSTMENT
KNOB FLAT WASHER
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Opera-
tion section, page 10, for location and
function of controls)
Press liftlever plunger and raise attachment lift lever to
its highest position.
Release parking brake by depressing clutch/brake pedal.
• Place gearshift lever in neutral (N) position,
Roll tractor forward off skid.
• Remove banding holding discharge guard up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera-
tion section, page 10, for location and func-
tion of controls)
_1,WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractoris in a well-ventilated area. Be sure the area in
front oftractor isclear of other people and objects.
Be sure all the above assembly steps have been
completed.
• Check engine oil level and fillfuel tank with gasoline.
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
• Place gear shiftlever in neutral (N) position.
• Pressliftleverplunger and raise attachment lift lever to
its highest position.
• Startthe engine,Afterengine has started, move throttle
controlto idleposition.
• Depress clutch/brake pedal intofull "BRAKE" position
and hold. Move gearshift lever to 1st gear.
• Slowly release clutch/brake pedal and slowly drive
tractor off skid.
• Apply brake tostop tractor, set parking brake and place
gearshift lever in neutral position.
• Turn ignitionkey to "OFF' position.
Continue with the instructionsthat follow.
7
Loading ...
Loading ...
Loading ...