Loading ...
Loading ...
Loading ...
ASSEMBLY
Your newtractor has been assembled at the factory withexception of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the
correct toolsas necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socketwrench set will make assembly easier. Standard
wrench sizes are listed.
(2) 112"wrenches Utility knife
(1) 9/16" wrench Tire pressuregauge
Pliers
When rightorlefthand ismentioned inthis manual, itmeans
when you are in the operating position (seated behind the
steeringwheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
• Slide extension shaft onto lower steering shaft. Align
mounting holes in extension and lower shafts and install
5/16 hex bolt and Iocknut. Tighten securely.
• Place tabs of steedng boot over tab slots in dash and
push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so they are pointing
straight forward.
• Remove steering wheel adapter from steering wheel and
slide adapter onto steering shaft extension.
• Position steering wheel so cross bars are horizontal (left
to right) and slide inside boot and onto adapter.
• Assemble large flat washer, 3/8 lock washer, 3/8 hex'
bolt and tighten securely.
• Snap steedng wheel insert into center of steering wheel.
• Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
BOOT
ADAPTER _ITEFNTSIO N
5116 HEX
BOLT
5/16
LOCKNUT _ J,
I \ \1
LOWER __"
STEERING i _ _"
SHAFT _ _ _ _ _ _ -- _
----'-----INSERT
_..._ 3/8HEXBOLT
(_r.----------_WASHER
TAB
SLOTS
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY (See Fig. 2)
• Lift seat pan to raised position and open battery box
door.
• If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" inCUSTOM ER RESPONSIBILITIES
section of this manual for charging instructions).
6
Loading ...
Loading ...
Loading ...