Loading ...
Loading ...
Loading ...
14
RESET
LED
RESET
LED
Special Functions
Automatic Power Up (APU) / Automatic Power Down (APD)
TUK is designed to save power when not in use. When no audio signal has been detected
for 15 minutes, TUK will put itself into standby mode (APD). If the audio signal returns via
the same input that TUK was playing when it entered standby, TUK will wake up and resume
playing (APU). It can also be woken up manually by:
• Pressing the Standby Button on the Remote
• Pressing the Control knob
If you do not nd the APU feature useful, you can disable it by pressing the
Treble Reset button on the remote and holding it for 5 seconds. The Input
LED will blink once to indicate that you have disabled the APU feature. To
enable APU if you have disabled it, simply press and hold the Treble Reset
button again for 5 seconds. The Input LED will blink twice to indicate that
you have enabled APU.
If you do not nd the APD feature useful, you can disable it by pressing the
Bass Reset button on the remote and holding it for 5 seconds. The Input
LED will blink once to indicate that you have disabled the APD feature. To
enable APD if you have disabled it, simply press and hold the Bass Reset
button again for 5 seconds. The Input LED will blink twice to indicate that
you have enabled APD.
ATTENTION
APU / APD is always enabled by default. APU will only activate after APD has been triggered. APU will
not work if the unit is manually switched to standby using the remote or control knob.
Bass / Treble Memory (BTM)
By default, TUK applies your EQ (bass & treble) settings to all inputs. If
you prefer to set individual EQ settings for each input, you can activate
Bass Treble Memory (BTM) by pressing and holding the Play / Pause
button for 5 seconds. The Input LED will blink twice to indicate that BTM
has been activated. You can deactivate BTM by pressing and holding
the Play / Pause button for 5 seconds. The Input LED will blink once to
indicate that BTM has been deactivated. BTM is disabled by default and
by Factory Reset.
Factory Reset
All settings on TUK can be reverted to factory default by switching the
Power Switch to the OFF position, waiting 5 seconds, then switching back
to the ON position.
LED Brightness
TUK's Input LEDs on the front panel can be adjusted to 5 brightness levels
including o. Cycle through the brightness settings by pressing the LED
button on the TUK remote. LED brightness can also be adjusted while
TUK is in standby mode.
Loading ...
Loading ...