Loading ...
Loading ...
Loading ...
MAKING RIP CUTS cont.
Using The Edge Guide
Your saw comes with an edge guide that allows you
to make parallel cuts in a sheet of wood, all at the same time,
To Attach the Edge Guide
1. Unplug the saw.
i_ WARNING: Failure to unplug the saw could result in accidental starting
! causing possible serious personal injury,,
I
2. Place edge guide through holes in base of saw (See Fig.20o)
3. Adjust edge guide to the desired length of cut,
4. Tighten the edge guide retaining screw,
Using the Edge Guide
1. Place the face of the guide firmly against the edge of
the workpiece, Doing this will give you a true cut without
pinching the blade_
2. BE SURE that guiding edge of the workpiece is straight
so you can get a straight cut°
3. Carefully guide the saw along the guide for a
straight rip cut°
4. DO NOT bind the blade in the cut.
Edge Guide
Place e
Guide Through Holes
SERVICE
WARNING: Preventive maintenance performed by unauthorized personnel
may result in misplacing of internal wires and components, which could cause a
serious hazard.
i .....
o All service that requires opening the saw MUST only be performed by a Sears Service Center.
All motor part represent an important part of the double insulation system and MUST only be
serviced by a Sears Service Center. Service performed by unqualified personnel could result
in a risk of injury,,
oWhen servicing this tool, ALWAYS use only identical replacement parts, Follow instructions in
the Maintenance Section of this manual, Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electrical shock or injury.
o Avoid solvents when cleaning plastic parts, Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to
remove dirt, carbon dust, etc.
24
Loading ...
Loading ...
Loading ...