Loading ...
Loading ...
Loading ...
TO ADJUSTTHE BEVEL SETTING
1. Unplug the saw,
WARNING: Failure to unplug the saw could result in accidental starting causing
possible serious personal injury_
2, Loosen bevel adjustment knob (See Fig° 17)_
3. Raise the motor housing end of the saw until you reach the desired angle setting on the bevel
scale (See Fig,. 17),
4. Tighten Knob securely,,
I WARNING: Attempting a bevel cut without the knob being securely tightened ca
n
1
result in serio us injury_....................................................
POSITIVE 0 ° BEVEL STOP (See Fig. 17)
Your saw has a positive 0 ° bevel stop, it was adjusted at the factory to assure 0° angle of the saw
blade for 90 ° cuts° However shipping can cause misalignment.
To Check
1. Unplug the saw°
............................. ,,m, .......................................... i_
I
WARNING: Failure to unplug the saw could result in accidental starting causing
possible serious personal injury°
2. Place saw in an upside down position on workbench (See Fig. 17).
3. Use a carpenter's square to check the squareness of the saw blade to the base on your saw_
...........Fig. 17 i i __aw Blade ........ Edge Guide : _'/ _"__.._'_
Retaining Screw f'K" __-_=_ %
-" _ _--4._ Bevel
-_ "_--__,_ Adjustment Knob.q_.___ _r-__ -- /
_ :___../ - Carpenter's
. _ _:_._/_ Square Bevel Scale ........... ,j
Bevel Scale Adjustment Screw
To Adjust
1. Unplug the sawn
WARNANG: Failure to unplug the saw could result in accidental starting,cau,si, ng
possible serious personal injury. ................................, ,,...................
2. Loosen bevel adjustment knob.
3, Loosen hex nut securing adjustment screw.
4. Turn screw and adjust shoe until square with saw blade°
5. Tighten hex nut and knob securely.
I z_ WARNmNG: Attempting to make cuts without knob securely tightened can result in
I
! serious {nJurY_ .................................................... ..........
22
Loading ...
Loading ...
Loading ...