Kenmore 79571355910 Bottom Freezer Refrigerator

Use & Care Guide - Page 45

For 79571355910. Also, The document are for others Kenmore models: 7135*, 7035*

PDF File Manual, 48 pages, Read Online | Download pdf file

79571355910 photo
Loading ...
Loading ...
Loading ...
TROUBLESHOOTING GUIDE
45
J
ICE & WATER
Problem Possible Causes Solutions
Icemaker is not
making ice.
Refrigerator was recently installed or
icemaker recently connected.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Icemaker not turned on. Locate the icemaker on/oç button and conorm that it
is turned ON.
The refrigerator is not connected to
a water supply or the supply shutoç
valve is not turned on.
Connect refrigerator to the water supply and turn the
water shutoç valve fully open.
Icemaker shutoç (feeler arm)
obstructed.
If your icemaker is equipped with an ice shutoç arm,
make sure that the arm moves freely.
Reverse osmosis water oltration
system is connected to your cold
water supply.
Reverse osmosis oltration systems can reduce the
water pressure below the minimum amount and
result in icemaker issues. (Refer to the Water Pressure
section.)
Not dispensing water. New installation or water line
recently connected.
Dispense 2.5 gallons of water (push for approximately
5 minutes) to remove trapped air and contaminants
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
The dispenser panel is locked.
Press and hold the Lock button for three seconds to
unlock the control panel and dispenser.
The dispenser is not set for water
dispensing.
The dispenser can be set for ice or water. Make
certain that the control panel is set for the proper
operation. Press the Water button on the control panel
to dispense water.
Refrigerator or freezer doors are not
closed properly.
Water will not dispense if any of the refrigerator
doors are left open.
Water olter has been recently
removed or replaced.
After the water olter is replaced, dispense 2.5 gallons
of water (push for approximately 5 minutes) to remove
trapped air and contaminants from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
Tubing connecting refrigerator to
house supply valve is kinked.
The tubing can kink when the refrigerator is moved
during installation or cleaning resulting in reduced
water pow. Straighten or repair the water supply line
and arrange it to prevent future kinks.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
Connect refrigerator to the water supply and turn the
water shutoç valve fully open.
If the problem persists, it may be necessary to contact
a plumber.
Loading ...
Loading ...
Loading ...