Kenmore 79095914200 electric range

User Manual - Page 31

For 79095914200.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Loading ...
General Care & Cleaning
Removing and Replacing Warmer Drawer
Left Glide
Pull up with finger
Figure I
To Remove and Replace Warmer (Warm & Ready TM) Drawer
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the rightglide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locateglideleveroneachsideofdrawer, pullupontheleftglideleverandpush
down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (see figure 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer into the range untillevers "click" (approximately 2"). Pull the
drawer open again to seat bearing glides into position. If you do not hear the F_
levers "click" orthe bearing glides do not feel seated remove the drawer _Z
and repeat steps 2-4. This will minimize possible damage to the bearing _,_
glides. _o,_
C
Figure 2
Oven
Ught,
Wire
Holder
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
Changing the Oven Light
The oven light is located at the rear of the oven and is covered with a glass shield
held by a wire holder. The glass shield must be in place whenever the oven is in
use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.
31
Loading ...
Loading ...
Loading ...