Loading ...
Loading ...
Loading ...
7
4 Inspect hose couplings for proper placement of
rubber washers.
INSTALLATION INSTRUCTIONS - STEAM DRYER FILL HOSE
Water Connection
WATER SUPPLY REQUIREMENTS
Cold water faucet MUST be installed within 42 inches
(107 cm) of your dryer’s water inlet. The faucet MUST be
3/4 inch (1.9 cm) with threading for laundry hose con-
nection. Water pressure MUST be between 30 and 120
psi. Your water department can advise you of your water
pressure.
RUBBER WASHERS
MUST BE PRESENT
5 If your installation has room for the COLD water
supply to accept the “Y” connector directly, thread
the “Y” connector to the COLD water supply and
snug it by hand; then tighten it another 2/3 turn
with pliers.
6 If there is not room to install the “Y” connector
directly, thread the short extension hose on to
the COLD water supply and snug it by hand;
then tighten it another 2/3 turn with pliers.
7 Thread the “Y” connector to the short extension
hose and snug it by hand; then tighten it another
2/3 turn with pliers.
8 Connect the COLD inlet hose for the washer to the
“Y” connector and snug it by hand; then tighten it
another 2/3 turn with pliers.
9 Connect a 6' braided stainless steel fill hose from the
kit to the other outlet on the “Y” connector and snug it
by hand. Connect the hose’s other coupling to the
water inlet on the back of the dryer and snug it by
hand. Tighten each connection of the dryer inlet hose
another 2/3 turn with pliers.
10 Turn on the water and check for leaks at all
connections.
NOTE
If you were able to install the “Y” connector directly to
the COLD water supply, please skip to step 8.
WATER INLET
ON DRYER
DIRECT CONNECTION
OR WITH EXTENSION*
COLD WATER
SUPPLY HOSE TO
WASHER
Loading ...
Loading ...
Loading ...