Loading ...
Loading ...
Loading ...
6
a
b
c
d
raise
lower
a
e
f
g
b
c
d
Leveling your washer
Excessive noise and vibration can be prevented by
properly leveling the washer.
1 For free standing installation and with the washer
within 4 feet (1 m) of its final location, place a level on
top of the washer.
2 Use adjustable pliers to adjust the leveling legs so
the washer is level front-to-rear and side-to-side,
and stable corner-to-corner.
3 Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the washer sits solidly on the floor on ALL
four legs. Keep the leveling leg extension at a
minimum for best performance of the washer.
Connecting inlet water
COLD
HOT
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.
1 Run some water from the hot and cold faucets
to flush the water lines and remove particles that
might clog the water valve screens and to
determine which faucet is hot and which is
cold supply.
2 Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD inlet hose
to the COLD inlet connection on the washer.
Tighten by hand until snug. Then tighten each
supply connection another 2/3 turn with pliers.
Do not cross thread or over-tighten these connections.
3 Connect the HOT inlet hose to the HOT water
supply. Tighten by hand until snug. Then tighten the
supply connection another 2/3 turn with pliers.
Do not bend, kink or pinch water inlet hoses.
RUBBER WASHERS
MUST BE PRESENT
USE ONLY
NEW HOSES
Loading ...
Loading ...
Loading ...